MXG 1.2 Strada Street Icons
The AiM MXG 1.2 Strada Street Icons is a 7″ large, freely configurable TFT display without integrated data logging, external data logging is possible by adding the Strada logger. It has eight configurable RGB alarm LEDs, ten configurable RGB switch lights, two CAN ports to communicate with over 700 ECUs from all industry leading manufacturers and an input for a rear view camera. In addition, it has a three-axis accelerometer with gyroscope and magnetometer, eight analog inputs, one speed input, one lap time input, and two digital outputs.
The sturdy aluminum housing meets the requirements of the IP65 protection class, making the MXG 1.2 Strada Steert Icons suitable not only for touring cars, but also for open vehicles. The integrated buttons can be used to adjust the settings of the MXG 1.2 Strada Street Icons and switch between the configured pages.
Special features MXG 1.2 Strada Street Icons
- 8 freely configurable analog inputs
- 10 RGB switching lamps
- 8 RGB alarm lamps
- Display of lap times, up to 5 split times
- 1 Speed input
- Triaxial accelerometer, gyroscope
- 3 CAN interfaces
- Input for rear view camera
Technical data AiM MXG 1.2 Strada Street Icons
Rev counter | Tapping from control unit (CAN/RS232/K-Line/OBDII) or terminal 1 of ignition coil Measuring range 0 to 22,000 rpm End of scale adjustable in steps Sampling rate 10, 20 or 50 Hz Freely configurable "over-rev" control LED |
Timekeeping | Triggering via infrared, manual or GPS Lap times without limit, up to 5 split times Measuring accuracy 1/100 sec. Lap time prediction |
Analog channels | 8 inputs (0-5 V, 12 bit) Thermocouple 0 -1200°C, measuring accuracy + 0.75% Thermocouple resistance up to 180°C, measuring accuracy + 1 6 RGB alarm LEDs for under- and overrange of the set alarm values Display in °C or °F Sampling rate 1 - 1000 Hz, freely selectable Day and total odometer |
Speed | 1 digital input Acquisition via inductive wheel speed sensor ABS or CAN/RS232/OBDII 0 - 438, display in km/h or mph sampling rate 10 - 50 Hz, freely selectable |
Acceleration | triaxial ± 5 g, gyroscope and magnetometer integrated in display Sampling rate accelerometer 1 - 100 Hz, freely selectable Sampling rate gyroscope 1 - 50 Hz, freely selectable |
Gear indicator | Calculated from RPM and speed, detected via gear sensor or CAN/RS232/OBDII |
Total sampling rate | 8950 Hz (without ECU) |
Plug | 1x AMP 14pin 1x AMP 23pin 1x Binder 711 5 pin 1x Mini-USB on harness |
Shift flash | 10 freely configurable RGB LEDs, optionally gear-dependent |
Additional functions | Display of the difference to the fastest lap in the split times Lap time prediction Wifi connection Brightness sensor for display illumination 2 digital outputs Calculated channels Freely configurable display |
Data storage | No |
Data transmission | USB |
Power supply | via 12V on-board power supply On / Off via ignition switch no data loss after switch off |
Updates | Soft- and Firmware updates free of charge via Internet |
Dimensions | Housing: 237 x 127.6 x 26 mm Display: 152.8 x 91.8 mm |
Weight | 950 gr |